![background image](http://html.mh-extra.com/html/faac/xr4-433-c/xr4-433-c_manual_535409007.webp)
3
ENGLISH
5 FUNCTION LOGIC
6 OUTPUT 4 ACTIVE TIME PROGRAMMING
If you give a pulse to channel 4 from the radio control, output 4 (closed contact) is activated for a programmable time varying
from
a minimum of 1 sec to a maximum of 127.5 minutes
.
To programme time, first of all
select, with dip switch 2, the time base
with which the board will count (
see table fig.1
); next press
the SW5 key (Fig.1 ref.
8
) until you reach the selected time (LED DL6 briefly lights up whenever the relevant key is pressed). Wait for
5 secs.
without pressing any key
, until LED DL6 lights up on steady beam for 3 seconds. (To exit programming)
EXAMPLE 1:
OUTPUT ACTIVATION TIME 4=5 minutes
1) Select 30 secs. time base
(Dip-switch 2 OFF )
2) Press key SW5 (Fig.1 ref.
8
) 10 times.
(time base 30 secs. X 10 pressings = 5 min.)
3) Do not press any key for 5 secs. until you exit programming.
EXAMPLE 2:
OUTPUT ACTIVATION TIME 4=20 seconds
1) Select 1 sec. time base.
(Dip-switch 2 ON )
2) Press key SW5 (Fig.1 ref.
8
) 20 times.
(time base 1 sec. X 20 pressings = 20 sec.)
3) Do not press any key for 5 secs. until you exit programming.
IF OUTPUT 4 IS ACTIVE, LED DL4 IS LIGHTED, WHEREAS LED DL6 FLASHES ACCORDING TO THE SELECTED TIME
BASE
SLOW FLASHING DL6
30 SECS. TIME BASE SELECTED AND OUTPUT ACTIVE
FAST FLASHING DL6
1 SEC. TIME BASE SELECTED AND OUTPUT ACTIVE
TO MODIFY OR CHANGE ACTIVATION TIME OF OUTPUT 4, REPEAT THE PROGRAMMING OPERATION.
USCITA
CHANNEL
1
CHANNEL
2
DIP-SWITCH 1 OFF
CHANNEL
2
DIP-SWITCH 1 ON
CHANNEL
3
CHANNEL
4
OUTPUT 1
PULSE
/
/
/
/
OUTPUT 2
/
PULSE
CONTACT CLOSED
UNTIL NEXT PULSE
FROM REMOTE
CONTROL
/
/
OUTPUT 3
/
/
PULSE
/
OUTPUT 4
/
/
/
/
CONTACT CLOSED
UNTIL END OF
PROGRAMMED TIME
You can command the receiver channels from different radio controls. (E.g.: radio control 1 commands
channel 1, radio control 2 commands channel 2, etc..)
PULSE FROM RADIO CONTROL
2) The LED (Fig.1 ref.
5
) relating to the pressed push-button flashes for the first 5 secs., and then flashes more quickly
for the next 5 secs.
3) The LED lights up on steady beam for 2 secs. and then goes OFF.
4) Release the pressed push-button when the relevant LED lights up on a steady beam.
Содержание XR4 433 C
Страница 1: ...XR4 433 C XR4 868 C ...