3/4
6
Setting the radar sensitivity by push button
Each
short press
on the right button increases the size
of the radar sensing field.
Each
short press
on the left button decreases the size of
the radar sensing field.
7
IR presence sensing field : width
2m
35
cm
1m
35
c
m
Make sure to introduce the front
prism into the foreseen slides
in front of the lenses!
Above 3 m mounting height, use the narrow prism!
8
IR presence sensing field: depth (negative angle available)
+4°
-4°
0°
The pin shown here above indicates
the angle adjusted.
To approach the curtain to the door, turn the
screw clockwise. To tilt the curtain out, turn the
screw counterclockwise.
Å
Keep a
minimum distance of 5cm
between the door and the curtain.
9
Launching a setup
Short setup
Cut and restore power.
Recommended after adjustments by push buttons.
The sensor takes a new reference
picture.
Assisted setup
Press and hold the right push button until the LED flashes
RED-GREEN.
Recommended after first installation or mechanical
adjustments of the IR-module.
The sensor performs a door opening
and closing cycle to check the influence
of the door leaves on the safety curtain.
LED display during setup
RED-
GREEN
LED
Setup-process active: the sensor learns its environment. After finishing the setup process, the sensor shows the following behavior:
NO LED
The sensor successfully finished its setup.
RED LED flashing quickly
The sensor ‘sees’ the door movement and can not finish its setup (see troubleshooting).
ORANGE LED continuously on The sensor encounters signal saturation (see troubleshooting).
2 curtains of 24 overlapping spots
(no holes between spots)
2 curtains of 12 overlapping spots
(no holes between spots)
