![background image](http://html1.mh-extra.com/html/faac/faac-pro-2-4ga/faac-pro-2-4ga_installation-instructions-manual_535594023.webp)
23 |
P a g e
Keypad overview
This keypad has 3 outputs, all independent from the intercom/app relays. The diagram below
shows the LED indicators which indicate programming and relay status information.
RED when incorrect codes entered and outputs are locked out.
1
2
3
4
5
6
7
8
9
*
0
#
SLOW FLASHING - in normal standby mode.
ON in programming mode.
ON when relay 3 activated.
GREEN when output 1 activated.
RED when output 2 activated.
CLEAR when output 3 activated
FAST FLASHING
– Wrong code entered / error.
TIP
: After power up, as a security precaution, the keypad cannot be programmed for 60 seconds.
Once this time elapses, you may begin.
TIP
: Flashing amber LED is normal standby mode!
Keypad Programming
0
0
0
0
*
*
Quick start guide
1) Enter programming mode (amber LED should be ON)
1
0
2
0
0
?
?
?
?
#
0
2) Enter a new user code...
*
*
3) Exit programming mode
4) Enter the new user code to check the relay clicks.
Full Keypad programming
Enter programming mode..
0
0
0
0
*
*
Exit programming mode..
*
*
Enter a new ENGINEER/INSTALLERS
code…
Go into programming mode firstly then enter the following sequence…
Location
0
1
?
?
?
?
4-8 digit code
Validate
#
Tip:
The engineer code
must be the same length as
user codes. If using a 6 digit
engineers code, then user
codes must also be 6 digits
long etc.
The unit is now in programming mode. Amber LED on the
keypad should remain permanently on. 0000 is the default
programming passcode.
The unit should exit programming mode and the amber LED
should start flashing again.
Replace ???? with your new ENGINEERS
code.