FAAC A952, Руководство пользователя, Страница: 61 / 94

A952 59 532310 - Rev.A
47
9.2 FINAL CHECKS
1. For doors in “LOW ENERGY” mode, make sure that
the kinetic energy of the leaf is less than 1.69 joules
and that the maximum static force is less than
67 N. Use an impact force tester in accordance
with standard EN 12453. For non-EU countries,
of there are no specific local regulations, the force
must be less than 67 N.
2. For doors that are not in “LOW ENERGY” mode,
make sure that the test object is detected in all
areas covered by the leaf movement.
3. If the door is used as an escape route, make sure
that the manual opening force does not exceed
150 N measured at the end of the leaf at a height
of 1 m from the ground.
9.3 FINAL OPERATIONS
1. Install (
47
):
- The press-on front cover and fasten it using the
4 screws
- The press-on slot covers
-
The adhesive logo
2. For doors less than 2 meters high, apply the hazard
warning pictograms (supplied) in correspondence
with the arm movement area.
3. Highlight all areas with adequate warning signs
in which there are still residual risks, even if all
possible safety measures having been adopted.
4. Place a “DANGER, AUTOMATICALLY CONTROLLED”
sign in a prominent position on the door.
5. Attach the CE marking on the door.
6. Fill out the EC declaration of conformity and the
system register.
7. Give the EC Declaration, the system register with
the maintenance plan and the instructions for use
of the automation to the system owner/operator.