9
1.
Prepare the operator for installation as
follows:
– Remove the plastic cover from the
rack ram (fig. 15).
– Fit the release device (see section 7
page 12).
2.
Remove the cover plate from the
foundation box (fig. 16).
3.
Manually fit the gate at its half
opening position (angle a, fig. 17).
Caution! Failure to fit the gate at the
right angle will prevent the gate from
opening or closing fully on
completion of the installation.
To determine the precise angle a,
measure the length of line L (fig. 17)
and position the gate at the mid-point
of the line.
4.
Fit the operator inside the box and
engage the rack ram with the pinion in
the box (fig. 18).
5.
Fix the operator in place with the four
M8 bolts provided (fig. 18). If possible,
use a torque wrench to tighten the
bolts to 2.6 Kgm.
6.
Release the operator (see section 7)
and manually open the leaf to check
that the mechanism operates
smoothly.
7.
Connect up the cables to the
electronic control unit (see relevant
instructions).
Fig. 16
4.4 Installing the Operator
Fig. 15
Fig. 17
Fig. 18