![background image](http://html1.mh-extra.com/html/faac/4400/4400_installation-instructions-manual_3059381013.webp)
P a g e
|
13
Status LEDs
If you send another signal level check, *20#, you may find that if the network mode was on
3G before, that it is now on 4G mode.
CPU
Flashing = standby
Constant ON/OFF = busy
SIGNAL STRENGTH
1 flash = poor (1 bar)
2 flashes = low (2 bars)
3 flashes = good (3 bars)
4 flashes = Strong (4 bars)
5 flashes = searching
POWER
MODEM
Flashing = standby
Constant ON/OFF = searching
Do NOT use fine gauge cable such as CAT5, CAT6, Alarm Cable
etc to power this device as damage will occur.
0-2 metres (6 feet)
– min 0.50mm
2
(18 gauge)
2-4 metres (12 feet)
– min 0.75mm
2
(16 gauge)
4-8 metres (24 feet)
– min 1.0mm
2
(14 gauge)
The CPU, signal strength and power status LEDs are underneath the
modem and so the diagram below shows the board without the modem for
convenience.
Содержание 4400
