
www.f-onekites.com
1 -
Determine the wind direction.
2 -
Unroll your kite and position it so that one of its wing tips is located upwind
from the other. Place some sand on the upwind wing tip of the kite.
3 -
Before using the pump, operate it a few times to eject any sand left in the tube.
This will prevent any sand from entering the kite’s bladders.
The first few times you inflate your kite, pump the air into each bladder until it
is halfway full and « massage » it in order to correctly position the bladder inside the
strut. Finish the inflation until the bladder is firm and full. Struts are equipped with
ball stoppers thus no need to pinch the valves. Careful, do not try to push the valve
inside as you would do with an inflatable toy.
Inflate the struts to 12 PSI.
4 -
Inflate the leading edge bladder last. Remove the sand from the kite and stand
with your back facing the wind, attach your pump to your kite with a larks head knot
using the connector next to the leading edge valve.
5 -
Pump until it’s firm and wrinkle-free. Make sure the defaltion valve is properly
closed and sealed off with the Velcro cover.
Inflate the leading edge to 10 PSI.
6 -
Place your kite on its leading edge with the struts pointing downwind and secu-
re it putting sand on it.
SETTING UP YOUR KITE
7
Содержание Bandit Dos
Страница 1: ...www f onekites com...
Страница 9: ...www f onekites com 8 SETTING UP YOUR KITE WIND 1 2 3 4 5 6...
Страница 11: ...www f onekites com SETTING UP YOUR KITE 10 1 2 3 4 5 6 WIND...
Страница 20: ...www f onekites com...