57
The wheel is tightly secured when the serrated surfaces of the
5.
quick release clamping parts actually begin to cut into the bicycle
frame/fork surfaces.
Note that the same procedure applies when operating a quick
6.
release seat post binder mechanism.
If you can fully close the quick release without wrapping
your fingers around the fork blade for leverage, and the
lever does not leave a clear imprint in the palm of you
hand, the tension is insufficient. Open the lever, tighten the
adjusting nut, and try again. Continue until the QR lever
closes properly. Secondary retention devices are not a
substitute for a correct quick release adjustment. Failure to
properly adjust the quick release mechanism can cause the
wheel to wobble or disengage, which could cause you to
lose control and fall, resulting in serous injury or death.
!
Tighten both rear wheel axle nuts or the quick release
mechanism securely. Failure to do this may cause the rear
wheel to dislodge from the frame dropouts resulting in
serious damage or injury.
!
Rear Wheel
QUICK RELEASE LEVERS
It is important to check the quick release levers before every ride to ensure
all connections are made properly and securely.
Periodically, disassemble the mechanism from the
bicycle and inspect for any wear or damage and replace if
necessary. When reinstalling, it is very important to ensure
the connections are made properly.
!
