Ezgo RXV ELECTRIC, Руководство пользователя и руководство по обслуживанию

Страница: 39 / 122

OPERATION AND SERVICE INFORMATION
Page 19
Owner’s Guide
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings.
B
B
Do not overfill engine. Too much oil may cause smok-
ing or allow oil to enter the air filter enclosure.
Fig. 31 Add Engine Oil
The oil dipstick and cap must be in place before operating the
engine. Failure to install the dipstick and cap will result in oil
being discharged into the engine compartment.
As a final check, check the oil level again with the vehicle
on level ground. Like all liquids, oil increases in volume
when warm. The full ‘H’ mark on the dipstick is calibrated
for an engine at operating temperature. When the engine
is cold, the oil will be below the full mark. The engine can
be operated safely as long as the oil is within the safe
operating range as indicated on the dipstick.
DO NOT
operate the vehicle if the oil level is below the safe
area indicated on the dipstick.
AIR CLEANER INSPECTION AND REPLACE-
MENT
The air cleaner unit on the vehicle is a dry unit. DO NOT use
oil on the filter element or any part of the unit.
Fig. 32 Air Cleaner
The air cleaner may be accessed by raising the seat.
Unsnap the clip and twist in a counter clockwise direc-
tion to remove the cover. Inspect the air filter; replace
the air filter in accordance with the Periodic Service
Schedule. Clean the inside of the cover and canister. In-
stall the air filter element and cover; twist the cover in a
clockwise direction and latch the clip.
Fig. 33 Air Cleaner Assembly
CLEANING THE AIR FILTER ELEMENT
DO NOT use compressed air to clean the air filter.
Doing so will damage the filter and will cause damage
the engine.
If the element is in acceptable condition, loose dirt may
be removed by tapping the filter lightly
. DO NOT use oil
on the filter element or any part of the unit. Install the ele-
ment in the same way it was removed, being sure that the
filter cover is fastened securely and the clip is latched.