4 - 9
OPERATING PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
Changing Performance Options
The performance option may be changed if the
existing option is not compatible with the terrain
that the vehicle will be operated.
1. Raise the seat and ensure that the Run-Tow/
Maintenance switch is in the ‘RUN’ position.
2. Ensure that the charger is unplugged from the
vehicle.
3. Locate the vehicle diagnostic port and remove
the environmental cover.
4. Connect the handheld diagnostic tool and select
the desired performance setting.
5. Disconnect the handheld diagnostic tool, replace
the environmental cover and seat.
At monthly intervals, test the TCT system by allowing the vehicle to roll down an incline with the accelerator pedal
released. Braking force should be felt at approximately 2 mph (3 kph) indicating that the TCT system is functioning.
If vehicle speed continues to rise, apply the service brake to control speed and proceed with diagnostic check.
Charging the vehicle will also de-activate the diagnostic mode and the handheld diagnostic tool will not operate. The two-position
‘Run-Tow/Maintenance’ switch is located under the passenger side of the seat on the ESC environmental cover.
Operation
With the switch in ‘TOW/MAINTENANCE/STORAGE’ position:
the controller is deactivated.
the electronic braking feature is deactivated which allows the
vehicle to be towed or roll freely.
the warning beeper is deactivated.
With the switch in ‘RUN’ position:
the controller is activated.
the electronic braking feature and warning beeper features are
activated.
TCT vehicles operate only in the ‘RUN’ position.
If all of the following events occur with the switch in ‘RUN’ position
a) the vehicle has been stopped for more than one second.
b) the accelerator pedal has been released for more than one sec-
ond.
c) the vehicle begins to roll above 2 mph (3 kph).
the electronic braking will limit speed to approximately 2 mph (3 kph)
and the warning beeper will sound. When the accelerator pedal is
depressed, the electronic braking and warning beeper will be overrid-
den and normal vehicle operation resumes. The system functions in all
key switch positions.
Performance
Option
1. Airport
2. Golf Flat
3. Golf Steep Hills
4. Golf Mild Hills
5. Freedom
Top Speed
4 - 8 mph
(6 - 12.8 kmph)
10.2-14.8 mph
(16.4-23.8 kmph)
10.2-14.8 mph
(16.4- 23.8 kmph)
10.2-14.8 mph
(16.4- 23.8 kmph)
14.5 - 19.5 mph
(23.3- 31.3 kmph)
Compression
Braking
Strength
None
None
None
Heavy
Mild
Anti-Stall
Protection
Yes
Yes
Yes
Yes
Yes
Performance Options
NOTICE
Controller
Environmental
Cover
RUN
TOW
MAINTENANCE
STORAGE
TOWING - Always select
‘TOW MAINTENANCE STORAGE’
position before towing
WAIT 30 seconds after reconnecting batteries BEFORE
turning key switch to ‘REVERSE’, ‘FORWARD’ or
‘NEUTRAL’ positions.
ALWAYS turn key to ‘OFF’ before
disconnecting or reconnecting battery wires.
ELECTRICAL ARC or BATTERY EXPLOSION
can occur if key is not in the ‘OFF’ position.
To disable electrical system, turn key switch to ‘OFF’ and
remove battery wires.
DO NOT alter or tamper with this unit. Unauthorized
modifications can result in SERIOUS INJURY or damage
to the vehicle and will void the warranty.
613048
NOTICE
Содержание 622014
Страница 1: ...622014 Owner s Guide ISSUED JULY 2011 REVISED APRIL 2013 ...
Страница 81: ......