ezee Cadence, Руководство пользователя, Страница: 7 / 16

7
Unpack
Carefully remove the bicycle by lifting it straight out of
the box (beware of the carton staples.) Remove packing
material around the bike and stand the bike on a clean
flat surface. Be sure to keep any part packages. Discard
box and packaging material only.
Dispose responsibly, recycle when possible.
Checklist
This box should contain....the eZeebike!
An accessory box containing.
a.
3 Ignition keys
b. 1 Pair of pedals
c. 1 Battery charger
d. 1 Power cord
e. 2 Fuses (30 amps)
f. Nylon ties
g. Heat shrink tubes (assorted pre-cut sizes)
h. 1 Hex Key #5
i. 1 Hex Key #3
j. 1 eZeebike User manual
k. Bike component manuals
j. 1 Battery
Tools required
Tools are the first step to proper assembly, you will need
Allen / Hex key metric set
Philips head screwdriver
Open-end flat wrenches metric measurements 6mm -
17mm
Assembly
Front wheel
Insert the hub motor wheel into the fork, ensure it is
snugly fitted in the dropout slots. Tighten nuts on both
sides till the wheel is secured. Tightening torque 35
Nm
Seat post
Insert into the seat tube and align. Tighten clamps and
ensure seat is firmly fastened. Tightening torque 16 Nm
Do not adjust the seat post beyond its maximum
extension mark.
Front Mudguard
The supports are attached to the sides and top of the
front fork, the mudguards are made of polycarbonate
and should not rattle when securely fastened.
Brakes
One of the most important safety features on the bicycle.
To minimize the risk of injury, ensure they are corrected
adjusted.
Ensure that the brakes are centered and that the wheel
spins freely when brakes are not applied.
If you have little experience with bicycle maintenance.
We recommend you get this done with your local bike
shop.
Accessories
Install any optional accessories you have purchased with
your bike. Read the manufacturer’s manual provided.
Battery
Insert key into keyhole located by the controller box and
turn key counter clockwise while pressing it in, so that it
arrives in the open position. Release the catch located
at the underside of the saddle to flip it over. Locate
the battery flanges in their slots in the battery holder;
then push the battery firmly into the holder until the
connecting pins are firmly in the battery sockets.
The fit can be tight when new, so it may be required to
apply gentle pressure. Once the battery is in position,
lock into place by turning the key one click clockwise
to the “OFF” position. Ensure that the key is in “OFF”
position until you are ready to ride.
Do not use excessive force to fit the battery, which could
result in damaging the connection sockets or pins.
If there is an A/C outlet near to where your bicycle is
parked. It may not be necessary to remove the battery
from the bicycle to charge.
Tyres
Ensure that the tyres are inflated to the correct pressure
of 45~ 60 psi. Well inflated tyres enhances the comfort,
safety and efficiency of your ride. Do not make max.
inflation of 75 psi, it makes an unfortable ride. Check
reommended inflation pressure as marked on the tyres.