Installation
Installation
Mounting
1. Measure backplane of filter system and mark
hole locations on wall (See Item 1).
a. Ensure marks are level, then drills holes
for anchors (if needed). Anchors must be properly
matched, to allow for wet weight of filter system.
b. Secure water filter to wall. (Anchors are not
required on solid wood cabinets.)
Water Connections
2. Use appropriate 3/8” fittings and tubing to allow
for a flow rate of 2.5 Gallons Per Minute (GPM)
(See Item 2).
Connect water filter inlet to cold watersupply.
Use approved flexible beverage tubingwhere
possible with correct sized tube clamps.
If hard plumbing is necessary then use only lead
free solder and protect filter housing from excessive
heat.
3. From outlet of water filter use no less than 3/8”
ID tubing to all specified equipment. It is only
permissible to decrease line size when multiple
lines are being used (See Item 3).
* Teeing the tubing should be done appropriately,
for example 3/8” x 3/8” x 3/8”. This is only to be done
at equipment location if line is to be used for other
equipment like your ice maker.
Initializing Water Filter
4. Check to see that O-Rings are lightly lubricated.
Do this by turning the cartridge counter-clockwise 1/8
turn when viewed from the bottom and looking on top
of cartridge. The O-Rings are the black rubber looking
rings on top. Re-insert the cartridge by turning the
cartridge clockwise 1/8 turn when viewed from the
bottom (See Item 4).
5. Turn water on at the inlet valve, slowly allowing
water to fill filter system.
6. Purge the filter housing so that there are no air
bubbles left in the water lines by operating the valves
on the beverage system.
7. System is now operational. Go back and check
every connection for possible leaks and repair if
required.
770-532-4743 678-936-1274
770-532-4743 678-936-1274