1
ATTENTION
Before any installation, it is required to:
1.
Check the condition of the engine battery
2.
For « Smart connect » installation,
a.
Check the vehicle's original wiring that must be ≥ 10 mm². If it is not the case go directly
page 4: Installation Dedicated Line
b.
Check that the vehicle is equipped with a coupling system if this is not the case go
directly Page 4: Installing Dedicated Line
Conn IN and + OUT of the module:
In
SMARTCONNECT
mode :
The + original service line (+EBL) = +IN terminal of the module
+ service battery = +OUT terminal of the module
In
DEDICATED
mode :
+ engine battery = +IN terminal of the module
+ service battery = +OUT terminal of the module
Choice of operating mode:
Setting the charging mode of the LiFePo battery cell from the engine battery:
PROCEDURE :
Remove the front panel (2 screws) and slide the cover towards the rear of the module
Mode n°1 SMARTCONNECT mode 50 Amp :
Intelligent
charger, it can be installed on an original manufacturer’ line
(in 10mm²) without the need to pull a specific load line. It then charges engine running, up to 50 Amp. Bi-directional,
it maintains the charge and floating mode when the vehicle is connected to the 110/220 volt mains. Complies with
the manufacturer's warranty conditions.
Mode n°2 DEDICATED MODE 60 Amp :
In some cases, it is possible or necessary to install a dedicated charging line
in 16² or 25²:
-
The diameter of the original manufacturer line is less than 10²,
-
The vehicle does not have a, engine battery coupling, when the engine is running, to
power the cell of the motorhome.
-
- The end user wants to recharge faster, up to 60 amp. Thus, this dedicated line will
increase the load performance, engine running, by 20% to charge up to 60 Amp.
1
2
