Ez One Shot MT8200H, Руководство пользователя

Страница: 6 / 54

HOW TO SET PARAMETERS
1. Use the scanner to scan at the bar code representing the function/
parameter you want to set.
2. When you hear two beeps, the new settings have been defined or
updated permanently to the scanner.
Default parameters are indicated in bold type and underlined
characters. The character font is ARIAL BLACK.
Most settings require only a single bar code, but a few need several
different bar codes to be scanned in order to completely define a
setting (i.e Multi-step Configurations). They are:
How do you program a scanner with this user’s guide?
Preamble / Postamble (maximum 16 digits)
Step 1: Scan CLR PRE/POSTAMBLE.
Step 2: Scan PREAMBLE or POSTAMBLE.
Step 3: Scan 1 ~ 16 alphanumeric from Full ASCII table (Group 31-42).
Step 4: Scan PREAMBLE or POSTAMBLE.
Min Length / Max Length
Step 1: Scan MIN LENGTH or MAX LENGTH.
Step 2: Scan two digits from Full ASCII table - Numbers (Group 39).
Step 3: Scan MIN LENGTH or MAX LENGTH.
Set Code ID (Example: Code 39)
Step 1: Scan CODE 39 SET ID from Group 7
Step 2: Scan either one or two alphanumerics (maximum 2 digits)
from Full ASCII table (Group 31-39)
Step 3: Scan CODE 39 SET ID from Group 7
1. The scanner will beep three times as indication that a setting is
not yet complete or unexpected barcode is scanned during multi-step
configuration.
2. If you make a mistake, forget a step, etc., and want to abort the multi-
step configuration, scan RESET/ABORT and start over again.
NOTES:
. P023$
*.P023$*
RESET/ ABORT