1-800-323-6598
www.ezonpro.com
INSTALLATION INSTRUCTIONS
1. Unlock seat and lift up.
2. Hang adjustable hooks from top of seat.
3. Close bus seat. Make sure non-adjustable
hook ends are extending on seat bottom.
Note: Securely lock seat bottom in place.
4. Connect push button.
Note: Face of Push Button should be against
the bus seat back.
5. Adjust length of seat wrap so that the bar
slide is at the top of the bus seat, and
non-adjustable hook ends are extending
approximately 2 inches on seat bottom.
6. Back thread loose end of webbing through
bar slide.
7. Pull webbing tight at the push button.
Mount strap must be tight without slack.
Note: Webbing should be tight enough to
create a crease on the top of the bus seat.
8. Properly seat passenger.
Note: Hips low against the back of the seat
and shoulders flush to the seat.
9. Attach the non-adjustable tether hooks to
the “D” rings located at the hip level of the
seating passenger’s vest.
10. To shorten or lengthen the hip tether hooks,
rotate seat mount.
Note: Passenger should not be able to
move bottom more than 2 inches forward.
11. Attach adjustable hook ends to tether slots
on the shoulder adjusters on the vest.
12. Tighten strap by pulling webbing through
the tilt lock adjuster.
Note: Repeat steps 11 - 12 for
second shoulder strap.
100SMU
SEAT MOUNT - Fits All Bus Seats
EZ-ON PRODUCTS
1-800-323-6598
www.ezonpro.com
FOR SCHOOL BUS USE ONLY
1
2
3
4
5
6
8
9
10
11
12
7