6
Assembling Your Rink | Boards (Part 1)
Step 1:
Start by assembling one layer (Classic Height) of boards to create your rink’s perimeter.
To begin, connect two
Corner Boards
together.
Stand one Board up straight, while sliding the
Board Connector
down it, so the two pieces
interlock. Place the
Board
in the slot of the red
PRO Bracket (as shown in Figure 1).
For best
results, the Brackets should sit slightly to the left or right of the Board Connector. The triangle
part of the Bracket should be outside of the rink. Make sure the
Bracket Buckles
are pulled
under the
Bracket
and sit inside the rink.
Then, slide the second
Board
down the
Board Connector,
placing it in the slot of a second
red
PRO Bracket, (as shown in Figure 2).
This is your first connection.
Continue these steps
around the perimeter of your rink, until you have the correct number of Boards on all sides.
IMPORTANT:
The second (Double Height) and third (Arena Height)
layers of boards do not go in until AFTER the liner is installed.
Figure 1
Figure 2
