1. Unplug extension cord from the wall outlet first and then remove all ornaments and decorations.
2. Disassemble the tree from the top to the bottom. Start with the tree top and gently lift straight up to remove from
section below and fold all branches toward the pole.
3. Continue by gently lifting straight up each section(s) from the section below and fold all
branches toward the pole until the bottom section is removed from the tree stand.
Replace the protective cap on the poles to avoid damaging the internal parts.
(See Fig. D)
4. Carefully place all tree sections into shipping box and tape (not included) it shut.
5. When not in use, please store your tree in a cool, dry place away from sunlight. Exposing
your tree to excessive heat or humidity may damage your tree.
STORAGE INSTRUCTIONS
For Pre-lit Trees, If The Tree Does Not Illuminate
1. Please check to make sure that all connectors are properly connected and the power adapter / extension cord is
plugged into the wall outlet.
2. Turn the poles gently to ensure pole-to-pole connection.
3. Check for loose, broken or missing bulbs and replace as needed.
4. Check on / off foot pedal.
Loose Hinge Pin
1. Extra hinge pins are included for repairing the hinges. Place the branch into the slot of the bracket.
2. Insert a new hinge pin through the hole and secure using the retainer washer.
(See Fig. E)
TROUBLE SHOOTING TIPS
Each tree includes hinge pins/washers and spare bulbs. If extra parts are
needed, please contact our customer service center.
SPARE PARTS
3. Each tree section is numbered with a label. Please identify all sections before assembling.
4. Assemble the tree from the bottom to the top
(See Fig. B)
. Start with the bottom section and remove protective
cap before inserting into the assembled stand. Make sure the pole is firmly inserted and secured into the stand.
5. Open the protective cap from the lower section(s) and continue inserting the upper section(s) until the tree top is
inserted.
6. Allow branches to fall into place or gently pull up and out. When adjusting branches, be sure that all wires are free
of branch hinges.
7. Plug the extension cord into a wall outlet
(See Fig. B)
, your entire tree should now be lit. If some bulbs do not light
or are flickering, search for any loose plugs and/or broken, loose or missing bulbs. Replace the bad bulbs promptly
in order to maintain the performance and life expectancy of your pre-lit tree.
8. This is a Simple Shape™ tree, just slightly upsweep all branch tips for a uniform look, no shaping required. If
needed, shape the branches and tips to make the tree look fuller. Your Christmas tree is now complete and ready to
be decorated.
(See Fig. C)
Top view
Side view
Fig. C
Fig. D
Fig. E
Page: 2 of 5
Press the selector button on the “Dual Color Light Controller” to
select among:
1. CLEAR STEADY 2. CLEAR FADING 3. MULTI-COLOR
STEADY 4. MULTI-COLOR FADING 5. CLEAR / MULTI-COLOR ALTER-
NATING 6. CLEAR / MULTI-COLOR FADING 7. DEMO
HOW TO USE THE DUAL COLOR LIGHT CONTROLLER:
Remote
Controller
Light
Controller
Selector Button
HOW TO USE THE REMOTE CONTROLLER :
The remote control is for the wired controller only:
(1) REMOVE THE INSULATION TAB OF THE REMOTE CONTROLLER.
(2) PRESS THE BUTTON TO SELECT DIFFERENT FUNCTIONS, REFER TO “HOW TO USE THE DUAL
COLOR LIGHT CONTROLLER”.
(3) TO REPLACE THE BATTERY, OPEN THE BATTERY COMPARTMENT WITH A COIN. REPLACE WITH
A CR2032 BATTERY.
