WARNING
• Risk of electric shock - This pump is supplied with a grounding
conductor and grounding type attachment plug. To reduce
risk of electric shock, be certain that it is connected only to
properly grounded, grounding-type receptacle.
• Risk of Electric Shock, Do not remove cord and strain relief.
Do not connect conduit to pump.
• This Pump Has Been Evaluated for Use With Water Only
• Reduce risk of electric shock during operation of this pump
requires the provision of acceptable grounding.
• Risk of electric shock – This pump has not been investigated
for use in swimming pool or marine areas
• Do not connect to any voltage other than that shown on the
pump.
• Always disconnect from electrical outlet before handling the
pump.
• Don’t operate without water.
• Operate pump completely submerged for proper cooling.
PERFORMANCE
A clogged or dirty intake screen will greatly reduce performance.
If the pump is used on a dirty surface, raise it slightly to reduce
the amount of debris contacting the intake. If less flow is desired,
adjust the flow control lever on the side of the pump or restrict the
discharge flow.
Do not let the pump run when not submerged in water. Doing so
may damage the pump. Always submerge the pump first, and then
plug in the electrical outlet. The pump is to be supplied through a
residual current device (RCD) with a rated residual operating cur-
rent not exceeding 30 mA.
MAINTENANCE
To clean the pump, remove the back cover and the impeller.
Use a small brush or stream of water to remove any debris
CAUTON: The pump shaft can not be removed.
IF THE PUMP FAILS TO OPERATE, CHECK THE FOLLOWING:
• Check the circuit breaker and try another outlet to ensure the
pump is getting electrical power. NOTE: Always disconnect
from electrical outlet before handling the pump.
• Check the pump discharge and tubing for any obstructions.
Algae build up can be flushed out with a garden hose.
• Check the inlet to ensure it is not clogged with debris.
• Remove the pump inlet to access the impeller area. Turn the
rotor to ensure it is not broken or jammed.
• Monthly maintenance will add to your pump’s life. NOTE:
• Ensure that the electrical cord loops below the electrical out-
let to form a “Drip Loop” This will prevent water from running
down the cord into the electrical outlet.
