™
Walk In Tub
Installation and Operating Instructions
®
www.ezable.com
877-392-2531
at or below the finished bottom edge of the panel so it
may be removed later should maintenance of the tub
be required. See foot adjustment.
Figure 3
8.
Carefully lift the walk in tub into position. Lower
so the tub rim sets on the metal hanger. Confirm the
tub fits as you expect into the installation area. Make
adjustments if necessary. Connect the water supplies to
the faucet and overflow drain assembly to
the waste pipe.
Take care when installing
the drain assembly to prevent damage to
the air tubing or piping underneath the
product.
9.
Check the entire tub for level. Tub should be level
from front to back and side to side. Adjust levelers as
needed by simply turning the levelers as required.
See
Figure 3B.
10.
The next step is to fill the tub for testing. Close
and latch the tub door and turn on the water. As it
fills, keep an eye on all fittings to check for leaks.
When the tub is 3/4 full, shut off the water and
recheck level. If the tub is not level, adjust the leveling
feet as required.
Note that the front center
leveling foot is for the door. If you notice any
leaking from the door, adjust this leveler as
needed.
11.
Apply a bead of 100% silicone caulking to each
point where the tub contacts the framing studs. Screw
the room side levelers to the floor to prevent the tub
from shifting.
12.
If you are using the Tub Extension Kit, you
probably will need to trim it before trial fitting.
Carefully measure and cut the extension kit.There
are a number of different configurations possible
depending on the specific installation.
Carefully consider how you want to finish the area
and install your support frame accordingly.
Wood framing must be constructed at the end of the
tub to support the Tub Extension Kit. An example of a
typical installation is shown in
Figure 7
.
The Extension Kit may be permanently attached by
using 100% silicone sealant or construction panel
adhesive. Apply adhesive to trimmed edge of the end
cap. Use care to avoid excessive use of adhesive so
it will not be visible after all finish materials have been
installed.
FIGURE 3B
Measure and trim
ends as required.
Tub Extension Kit
Tub
Rim
Extension
Kit Panel
Wall
Studs
Extension is held in place
with 100% silicone caulk
or panel adhesive.
Partial Room End View
Framing
for end
cap.
FIGURE 7
SerenityNow
Page 4 of 9
Содержание SerenityNow
Страница 2: ......