EyeView IPS-H110, Руководство по установке оборудования, Страница: 8 / 44

NONE (in blank line)
Green/White line
RS485-
Orange line
RS485+
Orange/White line
Audio in
Black line
NONE (in blank line) Red Line
2.2 Speed dome set up
Follow the description below setup IP speed dome’s hardware camera ID,
baud rate and protocol.
Speed dome setup Video platform setup AP (NVR2) setup
Camera ID, baud rate and protocol setting in these 3 item should be
the same for PTZ control function to work.
2.2.1
Setup camera ID, baud rate and protocol
Loosen the four screws and de-attached the dome cover from the housing.
Follow the tables below to setup each respective parameter. A 10-position DIP
SWITCH is furnished on the camera control board. SW1~ SW8 are for ID
address setting and SW9/SW10 are for burning firmware. Users don’t need to
set firmware burning settings. Respective setting is illustrated in the following
table:
N
o
Setting of camera ID Address