Extronics Limited, registered in England and Wales no. 03076287
Registered office 1 Dalton Way, Midpoint 18, Middlewich, Cheshire, UK. CW10 0HU
Tel:
+44 (0) 845 277 5000
Fax:
+44 (0)845 277 4000
E-mail:
Web:
www.extronics.com
8
6.
USB Charger/Cable
The iRFID500 is supplied with a USB charger/cable. When the reader is charging, the display lights up
and shows a blinking charge indicator message. The display shows a static message, “charge 100%”,
to indicate charging is complete.
Warning: The hazardous area certified versions of the iRFID500 must not be charged
within the hazardous area under any circumstances.
Attention: Empty battery condition
If the battery becomes fully discharged, the display may not illuminate when the USB
charger/cable is connected. If this occurs, leave the reader connected for at least 5
minutes, then disconnect the USB charger/cable and perform the reset procedure as
explained in
section 9
of this manual. Switch off the reader by pressing the power
button and then reconnect the USB charger/cable again.
Attention: Voltage levels
Note: only the USB charger/cable supplied may be used, as it provides the correct
voltages for the reader. Other USB cables are not suitable for charging the iRFID500.
The USB charger/cable should not be used to charge any other device as the higher
voltage level may cause damage to the attached device.
A micro USB type B socket is located on the bottom side of the iRFID500 and can be used to connect
the reader to a USB host port or to an AC/DC plug top charger.
