extronics iCAM501, Руководство по эксплуатации

Страница: 29 / 40

Operating Manual
29
The following window should be displayed:
To put the iCAM501 into upgrade mode, power the camera down and then press and
hold the ‘trigger’ and ‘flash enable’ buttons until the blue LED begins flashing (this
should be the only LED lit).
Next, plug a USB cable into the iCAM501, and into the PC. The upgrade application
should then prompt you to press the start button once it has recognised the iCAM501
is connected and in the correct mode. Follow the on-screen instructions.
Once complete, the camera will power itself off. Simply power it back on as normal
(press and hold the ‘flash enable’ and ‘record enable’ buttons together). It will now be
running the upgraded software.
2.11 Error Codes
•
If the green status LED continually flashed once booted, this means that the
batteries are running low and will soon need replacing.
•
If the iCAM501 has all 3 LEDs constantly flashing it means that it is in an
unrecoverable state. The only way to get it out of this state is to remove the
batteries and then replace them.