Extron electronics XTP T VGA, Руководство пользователя

Страница: 21 / 42

XTP T VGA Transmitter • Operation 13
Operation
This section contains information for front panel operation and configuration of the
XTP T VGA. Topics in this section include:
• Front Panel Features
• EDID
• Reset Mode
Front Panel Features
INPUT
S-VIDEO
VIDEO
RGB
YUV
AUDIO SIGNAL CLIP
XTP T VGA
CONFIG
A B C
Figure 9. XTP T VGA Front Panel
A Power LED indicators — Lights when power is applied to the unit. There are two
Power LED indicators, one on the front panel and one on the left side of the rear panel.
B Configuration port — If desired, connect a host device to the front panel USB mini-B
port for configuring the transmitter.
C
LED indicators:
•
Video LED indicator
— Lights when a composite video signal is detected.
•
S-video LED indicator — Lights when an S-video signal is detected.
•
YUV LED indicator — Lights when a component video signal is detected.
•
RGB LED indicator —Lights when an RGB video signal is detected.
•
Audio Signal Clip LED indicator
— Lights when the analog audio input signal is
-3 dBFS or above. The light remains lit for 200 ms after the audio input signal drops
below -3 dBFS.
EDID
To manage EDID on the XTP T VGA, use the XTP System Configuration Software (see
EDID Minder on page 31). The transmitter can record and save EDID in a user memory
location on the transmitter. EDID can come from the loop-through display on the transmitter
or the output display on the receiver.
NOTE: In matrix applications, EDID on the transmitter is assigned by the matrix switcher
using the XTP System Configuration Software.