Extron electronics XTP SR HDMI, Руководство пользователя

Страница: 21 / 54

XTP SR HDMI Scaling Receiver • Operation 15
F
Enter button — Press this button (see figure 9 ,
F
on the previous page) to navigate
the OSD menu or enable or disable front panel lockout mode (see Front Panel
Lockout Mode (Executive Mode) on page 22).
G Adjustment knobs — Rotate the horizontal (
[
) or vertical (
{
) adjustment knob (see
figure 9 ,
G
on the previous page) to navigate the on-screen display menu or adjust
submenu items.
Rear Panel HDMI Audio Switch
The XTP SR HDMI has an HDMI audio switch on the rear panel that
mutes or unmutes the embedded audio on the HDMI output connector
(see
figure 2 ,
D
on page 4). The LED next to the switch lights when
HDMI audio is enabled.
Move and hold the rear panel HDMI audio switch up until the Audio LED lights (about
1 second) to enable embedded audio on the associated HDMI connector, or move and
hold the HDMI audio switch down until the AUdio LED turns off (about 1 second) to disable
embedded audio on the associated HDMI connector. The switch returns to the middle
position after it has been released so the device can continue to be controlled through SIS
commands or from an XTP matrix switcher.
Audio Output Overview
By default, an XTP transmitter or matrix switcher prioritizes embedded digital audio over
analog audio. Use SIS commands (see
SIS Configuration and Control on page 23) or
the XTP System Configuration Software (see XTP System Configuration Software on
page 32) to manually select the audio input.
Audio Format Availability on Receiver Audio Outputs
Audio Output
Audio Input Format HDMI S/PDIF Analog
2-channel LPCM up to 48 kHz Yes Yes Yes
Multi-channel PCM up to 7.1, 192 kHz Yes
Dolby Digital up to 5.1 Yes Yes
Dolby Digital EX Yes Yes
Dolby Digital Plus Yes
Dolby TrueHD Yes
DTS Digital Surround up to 5.1 Yes Yes
DTS-ES Matrix 6.1 Yes Yes
DTS-ES Discrete 6.1 Yes Yes
DTS-HD Yes
DTS-HD Master Audio Yes
On-Screen Display Menu System
XTP SR HDMI configuration and adjustments can be performed by using SIS commands
(see
SIS Configuration and Control on page 23), the XTP System Configuration
Software (see XTP System Configuration Software on page 32), or by using the front
panel controls and the OSD menu. The OSD menu is used primarily when the receiver is
first set up.
NOTE:
The OSD menu has a fixed time-out of 10 seconds.
HDMI
OFF
ON
AUDIO