1
XTP R HWP 201 4K • Setup Guide
The XTP R HWP 201 4K is a single output XTP decorator-style wallplate receiver that can be installed into the provided mud ring or an optional UL
Listed metal junction box. This guide provides instructions for an experienced installer to install and connect the XTP R HWP 201 4K.
Throughput,
Power, and Control
Connectors
Input, Control, and
Front Panel Features
A
XTP input
connector
B
DC power
connector
C
LAN connector
D
RS-232 and
IR Over XTP
connector
E
Analog audio
output connector
F
HDMI output
connector
G
USB configuration
connector
H
HDMI audio switch
I
Reset button
Figure 1.
XTP R HWP 201 4K Rear (Left) and Front (Right) Panel Features
Installation
NOTE:
If a junction box is required, use a metal box only.
Ensure the installation meets building, electrical, and safety codes.
For additional mounting considerations, see the
XTP R HWP 201 4K
User Guide
at
www.extron.com
. For metal junction boxes, refer to the
manufacturer for additional mounting instructions and considerations.
ATTENTION:
Do not mount multiple devices adjacent to each other
in the same metal junction box. Add at least a one gang space
between devices.
Installing a Junction Box or Mud Ring
Follow the steps below if mounting the XTP R HWP 201 4K in a junction
box or mud ring.
Installation site preparation
1.
Use a soft pencil to mark guidelines on the mounting surface. For
accuracy, use a template or the mounting enclosure.
NOTE:
Install junction boxes against wall studs.
2.
Cut a hole in the wall. To avoid making the hole too big, cut inside
the marked lines.
3.
If using the mud ring in a wall with insulation inside, remove at least
6 inches of the insulation around the cutout. If a wall stud interferes
with removing the insulation, remove as much insulation as possible
between the cutout and the wall stud.
4.
Test the fit by inserting the mud ring or metal junction box into the
hole in the wall. If necessary, enlarge the hole as needed.
Metal junction box or mud ring installation
•
To install a UL Listed metal junction box (see figure 2), use mounting
screws to fasten the box to a wall stud.
•
To install the provided mud ring (see figure 3), attach the mounting
screws to the mud ring and loosely attach backing clips to the ends
of the screws. Rotate the backing clips so the mud ring fits in the
opening and then tighten them to fit snugly against the back of the wall.
XTP R HWP 201 4K
12V
0.8 A MAX.
POWER
XTP IN
HDMI OUT
LAN
CONFIG
HDMI
AUDIO
ON
OFF
RESET
AUDIO
Tx
L
R
IR
RS-232
Rx
Tx Rx
G
OVER XTP
Rear
Front
A
B
F
G
H
I
D
E
C
XTP R HWP 201 4K
Signal Output
Cable
Cable
Clamp
Decorator-style Faceplate
Screws or
Nails
Wall opening is
flush with edge
of box.
Wall Stud
e
Figure 2.
Metal Junction Box Installation
Backing Clip
Mounting Screw
Rotate the backing clip
out of the way to insert
the mud ring into the wall.
XTP R HWP 201 4K
Decorator-style Faceplate
e
Figure 3.
Mud Ring Installation