Contents
Extron • User’s Manual • VSC 100
Contents
VSC 100 • User’s Manual • Extron
Chapter 1 • Introduction
What is the VSC 100? ........................................................................................ 1-1
Features ......................................................................................................... 1-1
Output Formats .............................................................................................. 1-2
Specifications ................................................................................................. 1-2
Chapter 2 • Making Connections and Operating the VSC 100
Connecting the VSC 100 ................................................................................... 2-1
Output Connections ....................................................................................... 2-1
Panel Switches (Rear and Front) ................................................................... 2-2
Input Connections .......................................................................................... 2-3
Video Connector (Cable) Pin-outs ................................................................. 2-5
VSC 100 Front Panel Controls & Indicators ....................................................... 2-6
Troubleshooting Tips ...................................................................................... 2-7
The user is cautioned that any changes or modifications not expressly approved
by Extron Electronics could void the user’s authority to operate the equipment
per FCC regulations.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that the interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that of
the receiver.
•
Consult the dealer or an experienced radio/TV technician for help.
Note: This unit was tested with shielded cables on the peripheral devices.
Shielded cables must be used with the unit to ensure compliance.
VSC 100 Video Scan Converter
User’s Manual, 68-395-01, Rev C, 01 01
Written and printed in the USA
i
VSC 100 With VGA PC Input/RGBHV and NTSC/PAL Out
1
Turn the computer and its monitor Off. Remove power from the
VSC 100 at this time.
2
Connect composite video output to PAL monitor and the RGBHV
outputs to the projector.
3
Set front panel switch to RGB. Set the rear panel HV Out DIP
switch up. For PAL
video out, set the rear
panel PAL Out switch
up. For NTSC video,
set the PAL Out switch
down. Set all other
rear panel switches
down.
4
Disconnect the VGA
monitor from the PC
video output and plug
it into the rear panel
VGA Input connector.
Connect the VGA-Mac
adapter cable between
the rear panel Mac
Input connector and
the PC’s VGA video output.
5
Apply power to the VSC 100 and to each output device, and then
the VGA monitor and then to the PC.
MAC
INPUTS
OUTPUTS
COMPOSITE
S-VIDEO
R
G
B
H/HV
V
100-240V 0.9A
50/60 Hz
VGA
Monitor
HV OUT
P
AL OUT
75 OHM
SP
ARE
VSC 100
S-VIDEO
RGB
SCAN CONVERTER
SIGNAL
LOCK
3
S-VIDEO
RGB
HV OUT
P
AL OUT
75 OHM
SP
ARE
Front Panel
Rear Panel
6'
2
4
5
4
1
PC Monitor
PC Video Out
VGA
LCD Projector
