VersaTools
®
MTP Series • Installation
VersaTools
®
MTP Series • Installation
Installation, cont’d
CAUTION
Do not connect these devices to a computer data or
telecommunications network.
RJ-45 termination must comply with the
TIA/EIA T 568A or TIA/EIA T 568B wiring standards
for all connections.
5
Transmitter output and receiver input connector —
Connect
one end of a TP cable to this RJ-45 female connector on the
transmitter. On the MTP T SV A AAP and MTP T AV AAP, the
connector is at the end of a short pigtail.
Connect the free end of the same TP cable from the transmitter
to this RJ-45 female connector on the receiver.
6
Transmitter output connector (MTP T AV 45 and SVA 45) —
Connect one end of a TP cable to this spring force captive wire
connector on the transmitter.
Strip approximately 0.43" (1.1 cm) of insulation from each
individual wire on one end of a TP cable. Using the included
Tweeker tool and observing the correct wiring colors in the table
in figure 2-12, insert the stripped TP wire ends into the
connector (figure 2-11).
Connect the free end of the same TP cable from the transmitter
to the RJ-45 female connector,
5
, on the receiver.
Tweeker
Figure 2-11 — Inserting wires in a spring force
wire connector
Sleeve (Gnd )
Right Channel
(Red Jacket)
Left Channel
(White Jacket)
Tip (Signal)
Figure 2-9 — RCA audio connectors
Transmitter/receiver throughput connections
See figure 2-10 to identify the connections between the
transmitter and receiver.
12V
0.5a MAX
MTP Transmitters
MTP Receivers
12 VDC
.5A MAX.
OUTPUT
12345678
MTP T SVA 45
INPUT
L
R
MTP T AV
OUTPUT
VIDEO
12V
0.5a
INPUT
MTP T SV A RCA
OUTPUT
MAX
12V
0.5a MAX
S-VIDEO
L
R
OUTPUT
MTP R SV A RCA
INPUT
S-VIDEO
12V
0.5a MAX
OUTPUT
MTP R AV
L
R
INPUT
VIDEO
12V
0.5a MAX
R
L
5
5
5
6
Figure 2-10 — Throughput connections
2-11
2-10
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
