Extron electronics TouchLink TLP Pro 525C NC, Руководство пользователя

Страница: 32 / 51

NOTE:
Different countries require different power adapters. See
www.extron.com
to
select a power module that is suitable for your location.
CAUTION:
Risk of electric shock.
To ensure proper electrical grounding, use the
provided grounding screws and star washers.
ATTENTION : Risque de décharge électrique.
Afin d’assurer une mise à la terre
correcte, utilisez les fixations de mise à la terre et les rondelles en étoile fournies.
TLP Pro 725C
The TLP Pro 725C has three spaces
available for installing Series/2 modules.
If required, AAPs, retractors, and power
modules must be purchased separately.
See the Cable Cubby Builder on the Extron
website (
www.extron.com ) to select
suitable products. Make sure that the
power module is compatible with those
used in your region.
Figure 19 shows how to install an AC power
module. The Retractor bracket module, and
Series/2 Connectivity bracket modules are
installed in the same way.
Install the modules, as follows:
1. Insert the module into the cable cubby
(see figure 19,
1
). Make sure the
mounting holes on the module line up
with the holes on the enclosure.
Mount retractors in the far left or far
right end spaces at the lowest height
inside the touchpanel enclosure.
AC, AC + USB, and Series/2
Connectivity Bracket modules can be
mounted in any of the three spaces
and at any height.
2. Secure the module in position with
#6-32 Phillips head screws and
star washers (
2
) (see Special
Considerations for Power Modules
on the next page).
e
21-
525
-01
LF
21-
526
-01L
F
125
V~
12A
MA
X T
OTA
L
Insert the modules
into the Cable Cubby.
1
Secure the modules
using four of the
provided #6-32
pan-head mounting
screws and star washers.
2
Figure 19. Installing Power Modules in the
TLP Pro 725C
TLP Pro 525C and 725C Series Touchpanels • Mounting 22