Extron electronics TLP Pro 1225TG, Руководство по установке

Страница: 4 / 6

4
TLP Pro 1225TG and TLP Pro 1525TG • Setup Guide
Rear Panel Features
Figure 5 shows the TLP Pro 1225TG rear panel diagram (with the base and back cover removed). The features of the
TLP Pro 1525TG are very similar.
XTP /
PoE /
LAN HDMI IN
1
2
12VDC 3A
RESET
MENU
Marking
B
C
D
E
F
G
H
I
J
A
A
Rear status light
E
HDMI input
I Menu button
(see page 5)
B Vesa mounting holes F XTP/LAN/PoE input J Reset button (see page 5)
C
Power supply input
G Audio output
(see page 5)
D
USB connectors
H Reset LED
(see page 5)
Figure 5.
TLP Pro 1225TG Rear Panel (with base and back cover removed)
A
Rear status light — An LED light bar that can be programmed to provide system feedback.
B
VESA mounting holes (4) — For use with D-type VESA mounting kits with the 100 x 100 mm mounting pattern.
C Power supply input
— Connect a 12 VDC, 3.0 A Limited Power Source (LPS) power supply to this DC plug connector.
ATTENTION:
•
The touchpanels can use a 12 VDC desktop power supply or Power over Ethernet. Do not connect either power
supply before reading the Attention in the Power section of the
TLP Pro 1225 and TLP Pro 1525 Series User Guide .
•
Les écrans tactiles peuvent utiliser une source d’alimentation externe 12 Vcc ou l’alimentation POE via Ethernet.
Ne branchez pas de sources d’alimentation externes avant d’avoir lu les mises en garde dans la section
« Power Supply » du
TLP Pro 1225 and TLP Pro 1525 Series User Guide .
D USB connectors (2) — For peripheral controls.
E HDMI input
— For alternative video input.
F
XTP/LAN/PoE input
z
XTP input — Connect the touchpanel to the XTP source using a twisted pair cable, terminated with an RJ-45 connector.
For complete information about which cables to use, see the user guide for your XTP product.
z
LAN
input — Connect the touchpanel to the LAN using a twisted pair cable, terminated with an RJ-45 connector.
z
PoE input — The connector can be used with a PoE power injector (see
Connecting Power
on page 5).
NOTE:
Some XTP models are able to remotely power these touchpanels but not all have that capability. Go to the
Extron
website
and check the product page for your XTP model to ensure it can power your touchpanel.
An Extron IP Link Pro control processor must also be connected to the same network as the TouchLink Pro touchpanel.
figure 5
note