Using a UL-Certified Junction Box
1.
Locate a wall stud and mark the position where the junction
box will be placed. Use the size specifications provided by the
manufacturer.
2.
Cut a hole in the wall. To avoid making the hole too big, cut
inside the lines you marked in step 1.
3.
Test the fit by inserting the junction box into the hole in the
wall. If necessary, use a rasp or file to enlarge the hole.
4.
Insert the junction box into the hole in the wall. Secure it to the
stud using two screws or nails, as appropriate. The front edge of
the junction box must be flush with the front surface of the wall.
5.
Secure the wall adapter (provided) to the junction box, using the
four screws (provided).
6.
Connect a network switch to the "LAN In" port of the PoE
power supply (provided). Run a second cable from the "Pwr LAN
Out" port to the TLP 350MV mounting site (see the figure on the
previous page).
7.
Run video cables to the mounting site. Leave enough slack in the cables
to connect them to the TLP 350MV. Pull the cables through the mud ring.
8.
Connect the cables as shown in the diagram at the bottom of the previous page.
9.
Secure the TLP 350MV to the wall adapter. Two clips at the top and two at the bottom
audibly click when the panel moves into place. You should also use the two screws provided (top center and bottom
center).
10.
Do not replace the bezel at this time. You will need access to recessed the Menu and Reset buttons to configure the
unit.
Configuring the TLP 350MV (Initial Setup)
Before use, the TLP 350MV must be configured using the on-screen menus. There are five different screens (Main, Vol, Time,
IP, and Vid) that can be selected by pressing the appropriate button at the edge of the Main screen. There is also an
Exit
button at the bottom left corner of the screen for leaving the menus.
NOTE:
Only the Main screen provides links to the Vol, Time, IP, and Vid screens. All other screens have a link to return to
the Main screen. After calibrating each group of settings, return to the Main screen to access the next screen.
Setup Menu
1.
Press the recessed Menu button on the front panel to activate the
top-level menu screen. The menu opens at the Main Setup Page.
2.
Touch an area of the screen to bring it into focus and use the Up and
Down buttons or the volume control knob to adjust the value. Some
options have a single button and toggle between Off and On when
the button is pressed.
Use the different menu pages to adjust the following options. For more
details, see the user guide.
Main (shown at right) — Shows Power over Ethernet status and adjusts
the Sleep timer, Backlight, Auto Backlight, and LED Backlight functions.
Vol — Adjusts the Master, Click (global button sounds), and Sounds
(playback .wav files) volume settings.
Time — Sets the correct time and date.
IP — Sets the IP address and the subnet mask, and enables or disables Dynamic Host Configuration Protocol.
Vid — Provides a small video preview window and the controls to calibrate video contrast, color, brightness, and tint.
Main
Vol
Time
IP
Exit
Dn
Up
Dn
On
On
Up
On
Sleep: 00000 Sec
Backlight: 075%
Auto
Vid
LED Motion
Backlight
PoE
Active
Wall Stud
Junction Box
Wall Adapter
TLP 350MV
Bezel
PC
LA
PT
OP
DV
D
DO
C C
AM
AU
XIL
IAR
Y
DIS
PLA
Y O
N
DIS
PLA
Y O
FF
MU
TE
5
9
4
Screws (2)
