Extron electronics TLI Pro 201, Руководство пользователя

Страница: 15 / 46

An Extron IPL Pro Series or IPL Pro xi Series control processor must also
be connected to the same network domain as the TLI Pro 201. See the
www.extron.com for a list of suggested models.
The network port has two LEDs. The green Link LED lights steadily to indicate that
the TLI Pro 201 is connected correctly to a network. The amber Activity LED blinks to
indicate that data is being passed to or from the TLI Pro 201.
Connecting Power
ATTENTION:
•
Do not connect the power supply before reading the
Attention
on page 8.
•
Veuillez lire la partie « mises en garde » page 8
, avant de mettre sous tension
les écrans tactiles.
Extron recommends the Extron PI 140 power injector (see figure 3). Your power injector
may look different.
1.
Use an Ethernet cable to connect the LAN/PoE+ port of the interface to the power
output of the 802.3at, class 4 compliant PoE+ power injector.
This cable carries network information from the switch or router to the power supply
input.
2.
Connect the network input of the power injector to a network switch or router.
This cable carries the network information and power from the power supply to the
interface.
3.
Connect the IEC power cord to a convenient 100 VAC to 240 VAC, 50-60 Hz power
source.
100-240V
~
50-60Hz
0.4A MAX
XTP
PWR
XTP PWR
To network switch To TLI Pro 201
Figure 3. Connecting the Power Injector
Alternatively, use an Ethernet cable to connect the LAN/PoE+ port of the interface to a
PoE+ switch.
figure 3
TLI Pro 201 • Panel Features 7