Extron electronics SMP 111, Руководство пользователя

Страница: 96 / 124

SMP 111 • Reference Information 88
Extron USB Device
× ×
Ö Ö
Õ Õ
Figure 65. Communications Dialogs
3. Select the startup options:
a. If RS‑232 is selected (
Õ
), configure the port settings.
b.
If TCP/IP is selected (
Ö
), configure the IP address and Telnet port. Enter a
password, if necessary.
c. If USB is selected (
×
), choose Extron USB Device in the drop‑down window.
NOTE:
To automatically connect to the SMP 111, select Connect on Startup .
4. Click OK to connect to the SMP 111 and start using the program.
You are now ready to begin entering commands.
Open the
DataViewer Help File
from the toolbar for more information on the program.
Sending commands using a TCP/IP connection
1. Configure the network settings of a control PC so that it can be connected to the
same network as the SMP 111. Use an RJ‑45 cable to connect the control PC to the
network.
2. Start the DataViewer program (see Start the Dataviewer program on the previous
page) and follow the steps to connect to the SMP 111 via TCP/IP.
3. On the Communication Setup window (see figure 65):
a. Select the
TCP/IP
tab.
b. Enter the IP address of the SMP 111 into the Hostname/IP Address field.
c. In the Telnet Port field, enter the port number for the connection.
NOTE:
The default telnet port to send SIS commands to the SMP 111 is
port 23.
4. Click OK . The Communication Setup dialog closes.
figure 65