2
RGB 192 Analog Computer-Video Interface
Installation
This section contains detailed installation and operation instructions. The following is an overview of the installation
process.
Install and set up the RGB 192V interface by following these basic steps:
1.
Turn off all of the equipment (computers, remote controls, interface, projector or monitor, local monitor and speakers
or other audio device). Disconnect the power cords from the power source.
2.
Install the rubber feet for tabletop use (see
below).
3.
Connect the input computer (display, local monitor, and audio) (see
4.
Set the front panel DIP switches (see
5.
Connect power cords and turn on the output devices (projector, monitors, speakers), interface, and the source
computer.
6.
Adjust horizontal centering and set the Level DIP switch to obtain the best picture.
Mounting the Interfaces
The interface provides several mounting options: tabletop placement, under-desk mounting, or through-desk mounting.
Follow the appropriate procedure below or on page 3.
Tabletop placement
For tabletop or desktop placement only, install the self-adhesive rubber feet (provided) onto the four corners of the
bottom of the interface enclosure.
Under-desk mounting
1.
Secure the included under-desk mounting brackets to the interface with the machine screws that are already installed
in the side of the interface (see figure 2).
MON
ITOR
H-SH
IFT
SER
R
DDS
P
NO M
ON.
M. A
UDIO
SOG
LEV
EL
RGB
192
COM
PUT
ER
AUD
IO
1
ON
2
3
4
5
6
Figure 2.
Under-desk Mounting
2.
Hold the interface with attached brackets against the underside of the desk or other furniture. Mark the location of
holes for screws on the desk.
3.
Drill pilot holes 1/4 inch (6.4 mm) deep, and 3/32 inch (2 mm) diameter in the table or desk at the marked screw
locations from the underside/inside (concealed side) of the furniture, where the interface will be located.
4.
Insert the four wood screws into the pilot holes. Fasten each screw into the installation surface until just less than
1/4 inch of the screw protrudes.
5.
Align the installed screws with the slots in the mounting brackets, and place the interface against the surface, with
the screws through the bracket slots.
6.
Slide the interface slightly forward or back, then tighten all four screws to fasten it in place.
2
