Extron electronics Quantum Connect 82, Руководство пользователя

Страница: 69 / 93

Quantum Series Videowall Processing Systems • Operation 61
Using the Control Panel
The Quantum processor is a host device with Microsoft Windows XP embedded. The
Quantum Control Panel is a Windows-based program that is resident on the Quantum
internal disk or flash drive and enables you to perform various setup tasks, such as setting
the processor IP address or updating its firmware.
Starting the Control Panel
To access the Quantum Control Panel:
3. Ensure that the Quantum is powered down.
4. Connect a PS/2 or USB keyboard and mouse to the USB or mini-DIN connectors on
the Quantum rear panel (see
Keyboard, Mouse, Monitor, USB, and Media Cards
on page 46).
5.
Connect a monitor to the 15-pin VGA connector on the rear panel Media I and II card
(Quantum Elite 615) or Keyboard and Mouse card (Quantum Elite 408 and Quantum
Connect).
6. Power on the processor. The Quantum introductory screen appears on the monitor.
This screen displays the name and a photograph of a Quantum processor.
7. On the Quantum keyboard, hold down the <Ctrl> key while pressing <F2>. The
Control Panel
main window opens.
Figure 51. The Quantum Control Panel Main Window
8. Click one of the buttons at the bottom of the screen to proceed to the desired task
(see
Control Panel Buttons on the next page).
To close the
Control Panel
window, click Close in the upper-right corner.