PVT HD RGB
• Installation Guide (Continued)
68-3182-01
Rev A
11 17
© 2017 Extron Electronics, All Rights Reserved. All trademarks mentioned are the property of their respective owners.
www.extron.com
3.
Run the XTP DTP 24 cable from the PoleVault
switcher location, going behind the wall and to the
PVT location, then thread the cables through the mud
ring or wall box.
Provide strain relief and maintain optimum cable bend
radius (see Notes on first page)..
NOTES:
•
Extron highly recommends shielded twisted
pair (STP) cabling with shielded RJ-45 plugs.
•
The XTP DTP 24 cables supplied are
terminated to TIA 568B standard.
4.
Plug the XTP DTP 24 cable from the PoleVault switcher into the RJ-45 connector
labeled PVT Out on the rear of the wallplate
NOTE:
The two LEDs (Signal and Link) located between
the left and right front panels, mirror the Signal and
Link LEDs on the rear panel RJ-45 connector (see
image at right). These are useful for troubleshooting
the device without removing it from the wall.
5.
Mount the PVT wallplate into the mud ring or wall box
and attach the supplied decorator-style faceplate.
6.
Connect an HDMI source to the front panel HDMI input connector.
7.
Connect an RGB high resolution source device to the front panel VGA IN
connector.
8.
Connect an audio source to the audio input tip-ring-
sleeve jack. Wire the plug as shown at right.
NOTE:
To complete system installation, see the
Digital PoleVault System Installation Guide
(featuring the PVS 407D switcher),
available online at
www.extron.com
.
5
Pin
1
2
3
6
7
8
4
Wire Color
568B
White-green
Green
White-orange
White-blue
Orange
White-brown
Brown
Blue
12345678
RJ-45
Connector
Insert Twisted
Pair Wires
Pins:
SIGNAL
SERVICE
MI IN
DIO IN
LINK
AUDI
VGA
Sleeve (Gnd)
Ring (R)
Tip (L)
3.5 mm Stereo Plug
(unbalanced)
