Extron electronics NAV E 201 D, Руководство пользователя

Страница: 19 / 79

NAV E 401 D and NAV E 201 D Encoders • Installation 11
Front Panel Features
figure 6
HDMI IN HDMI OUT
E
STRM HDMI HDCP PWR
RESET
NAV 1G
ID
LNK
ACT
CONFIG
NAV - EXT
B B B D D D C C C A A A
F F F
E E E
NAV E 401 D
only
Figure 6. NAV E 401 D and NAV E 201 D Front Panel Features
NOTES:
• Figure 6 shows a NAV E 401 D. The NAV E 201 D is similar; the only exception is
lack of an Extension port (D).
•
Items
C
and
F
are visible only when the faceplate is removed.
Connectors
A
HDMI IN port — Receives the HDMI video input (or DVI, with an appropriate adapter)
from the HDMI output port of the digital video source.
B
HDMI OUT port — Outputs looped-through HDMI video for local monitoring of the
source signal.
NOTE: See LockIt Lacing Brackets on page 13 to securely fasten the HDMI
connectors (
C
and
F
) to the encoder.
C
Configuration (CONFIG) port — Connect a PC into the encoder for configuration
of the encoder. The port uses IP over USB technology; the IP address is always
203.0.113.22 and CANNOT be changed. The Config port is also discoverable via
Toolbelt and Product Configuration Software (PCS).
D
NAV - Ext(ension) port (NAV E 401 D only) — If desired, connect another networked
device to this port (see LAN and Ext connector on page 14 to wire the connector).
The port acts as a networked switch to the NAV 1G/PoE+ port (see
A
on page 9).
Lit Solid - Network link is established.
(0.5Hz) Flashing Green - Network link is
established at 100/10 Mbps.