NAV E 401 D and NAV E 201 D Encoders • Installation
9
Make Rear Panel Connections
1.
Connect the cables to the rear of the unit (see figure 4 for connector details).
POWER
12V
2.0A MAX
Tx Rx
S G
G
CONTROL
RS-232 IR
NA
V 1G/PoE+
+
C
C
C
B
B
B
A
A
A
Figure 4.
NAV E 401 D and NAV E 201 D Rear Panel Connectors
A
NAV 1G/PoE+ port
— Connect to an Ethernet LAN on which one or more decoders
also reside for streaming and control (see
the connector).
This port can also receive Power over Ethernet (PoE+) to power the encoder (see
on page 17 for power options).
B
Control RS-232/IR port
— Connect a serial RS-232 signal, a modulated IR signal,
or both to this 3.5 mm, 5-pole direct insertion connector for bidirectional RS-232 and
IR communication with connected remote controlled devices using an Extron control
system (see
on page 14 to wire the connector).
C
Power connector
(optional) — Connect the included external 12 VDC power supply
to this 2-pole direct insertion connector for local power (see
on
page 15 to wire the connector and
for power options).
Test and Troubleshoot
1.
Power up the system. Check that after approximately 45 seconds, the front panel LEDs
indicate normally (Power LED and Stream LEDs lit steadily green).
2.
Make adjustments to wiring or configuration as needed. Remember that the rear panel
ports are not accessible after the encoder is mounted.
Содержание NAV E 201 D
Страница 6: ......
Страница 8: ...NAV E 401 D and NAV E 201 D Encoders Contents viii...
