Extron electronics NAV E 101, Руководство пользователя

Страница: 14 / 80

NAV E 501 and NAV E 101 Encoders • Installation and Basic Operation 6
C
Audio input port (see page 5 ) — Connect balanced or unbalanced
L R
AUDIO
stereo audio input to this 5-pole, 3.5 mm captive screw connector (see
Analog audio connectors on page 8 to wire the connector).
D Control Contact Closure port — Connect an Extron Show Me cable to the
CONT
C T
port to allow an Extron Teamwork 400 user to request to take over the
presentation from this encoder (see the
Teamwork 400 User Guide , available at
www.extron.com ).
E
Control RS-232/IR port — Connect a serial RS-232 signal, a modulated
RS-232
Tx Rx G S G
IR
IR signal, or both to this 3.5 mm, 5-pole captive screw connector for
bidirectional RS-232 and IR communication (see
Control connector
wiring on page 8 to wire the connector).
F USB 2.0 port (NAV E 501 only) — Connect a USB Type-C cable from a USB
5V/500 mA
USB 2.0
host or a USB device. See LockIt Lacing Brackets on page 7 to securely
fasten the USB connector to the encoder.
NOTE: This connector is limited to supplying 500 mA in USB device mode.
G NAV 1G/PoE+ port — Connect to an Ethernet LAN on
NAV 1G/PoE+ EXT
LAN
which one or more decoders also reside for streaming,
control, and PoE+.
H Extension port (NAV E 501 only) — If desired, connect
another networked device to this port. The port acts as a
networked switch to the NAV 1G/PoE+ port (
G ).
NOTES:
• See TP cable termination on page 9 to properly wire the RJ-45 connectors
G and H .
• The Extension port (
H
) cannot provide PoE.
• RJ-45 port LEDs for both ports indicate as follows:
•
Act (amber) LED — Indicates transmission of data packets on the RJ-45
connector. This LED blinks as the encoder communicates.
• Link (green) LED — Indicates that the encoder is properly connected to
an Ethernet LAN. This LED lights steadily.
I Reset button and LED — The Reset button initiates three levels of encoder
RESET
reset. For the different reset levels, press and hold the button while the encoder
is running or while you power up the encoder (see
Reset Operations on
page 14 for details).
J
Power connector — Plug the included external 12 VDC power supply into
POWER
12V
2.0 A MAX
this 2-pole connector to power the encoder locally.
NOTE:
Alternatively, the encoder can be powered via PoE.
ATTENTION:
• Do not connect power to the encoder until you have read the CAUTION and
ATTENTION notices on page 10.
•
Ne connectez pas l’alimentation à l’encodeur avant d’avoir lu les rubriques
«
ATTENTION
» des page 10.