NAV E 501 and NAV E 101 Encoders • Installation and Basic Operation
9
TP cable termination
The encoder NAV 1G/PoE+ port supports 1000Mbps (1000base T — Gigabit Ethernet),
half-duplex and full-duplex Ethernet connections. It is vital that your Ethernet cable be the
correct cable type and that it be properly terminated with the correct pinout. Ethernet links
use Category (CAT) 5e or CAT 6, unshielded twisted pair (UTP) or shielded twisted pair
(STP) cables, terminated with RJ-45 connectors. Ethernet cables are limited to a length of
328 feet (100 meters).
NOTES:
•
Do not use standard telephone cables. Telephone cables do not support Ethernet
or Fast Ethernet.
•
Do not stretch or bend cables. Transmission errors can occur.
The Ethernet cable must be terminated as a patch (straight-through) cable and must be
properly terminated in accordance with the
TIA/EIA
T568-B
wiring standard (see figure 6).
5
Pin
1
2
3
6
7
8
4
Wire color
White-green
Green
White-orange
White-blue
Orange
White-brown
Brown
Blue
TIA/EIA T568B
TP Wires
12345678
Pins:
Figure 6.
RJ-45 Connector and Pinout Table
Power supply wiring
Figure 7 shows how to wire the connector. Use the supplied tie-wrap to strap the power
cord to the extended tail of the connector.
Power Supply
Output
Cord
Captive Screw
Connector
SECTION A–A
Ridges
Smooth
A
A
Tie Wrap
3
5
Figure 7.
Power Connector Wiring
