Specifications are subject to change without notice.
sPeCIFICaTIONs
Video
Gain ............................................... Unity
Video input
Number/signal type ........................ 1 set of proprietary analog signals
Connectors .................................... 1 female RJ-45
Video output
Number/signal type ........................ 1 RGBHV, RGBS, component video (bi-level
and tri-level), S-video, composite video
(follows input type)
Connectors
MTP U R RSA SEQ ........................ 1 female 15-pin HD for RGB
3 BNC female for Y, R-Y, B-Y
(1) 4-pin mini DIN for S-video (Y/C)
1 BNC female for composite video
All other models ........................... 1 female 15-pin HD for RGB or Y, R-Y, B-Y
(1) 4-pin mini DIN for S-video (Y/C)
1 BNC female for composite video
Nominal level .................................. 1 Vp-p for Y of component video and
S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of
component video
0.3 Vp-p for C of S-video
Minimum/maximum levels.............. 0.8 V to 1.2 Vp-p
Impedance ..................................... 75 ohms (during video output only)
Return loss ..................................... <-30 dB @ 5 MHz (during video output only)
DC offset ........................................ <±20 mV with input at 0 offset
Sync
Output type .................................... RGBHV, RGBS
Standards ........................................ NTSC 3.58, NTSC 4.43, PAL, SECAM
Output level ................................... 4.0 V to 5.0 Vp-p, unterminated
Output impedance ......................... 87 ohms (24 mA)
Polarity ............................................ Positive or negative (selectable)
Audio – Mtp u R RSA SeQ, Mtp u R A
Gain ............................................... Unbalanced output: 0 dB;
balanced output: +6 dB
Frequency response ....................... 20 Hz to 20 kHz, ±1 dB (for DC coupling,
with jumpers 4 and 5 installed)
THD + Noise .................................. 0.15% @ 1 kHz, 0.3% @ 20 kHz at nominal
level
S/N ............................................... >70 dB at maximum output (unweighted)
Audio input – Mtp u R RSA SeQ, Mtp u R A
See MTP Series transmitters’ audio output specifications
Number/signal type ....................... 1 set of proprietary analog signals
Connectors ..................................... 1 female RJ-45
NOTE:
0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu
Audio output – Mtp u R RSA SeQ, Mtp u R A
Number/signal type ....................... 2 mono, balanced/unbalanced
Connectors .................................... (1) 3.5 mm captive screw connector, 5 pole
Impedance ..................................... 50 ohms unbalanced, 100 ohms balanced
Gain error ...................................... ±1 dB channel to channel
contRol/ReMote – exteRnAl deVice
Pass-through, unidirectional or bidirectional
(MTP U R RSA SEQ, MTP U R RS SEQ or MTP U R RS)
Serial control port input/output ...... RS-232 via (1) 3.5 mm, 3 pole captive
screw connector
NOTE:
The serial communications link of an MTP U R RSA SEQ,
MTP U R RS SEQ or MTP U R RS is unidirectional only, transmitter to receiver,
unless the receiver’s internal switch has been set.
Baud rates ...................................... Up to 38400 bps at up to 500' (152 m)
(Higher data rates and distances are
possible. Performance will vary based on
baud rate and cable length.)
Protocol .......................................... Data bits = 5 - 8
Stop bits = 1 or 2
Parity = odd, even, none
Flow control = XON, XOFF, none
NOTE:
Protocol is mirrored between the transmitter and the receiver.
Serial control pin configurations ...... Captive screw connectors: 1 = TX, 2 = RX,
3 = GND
GeneRAl
External power supply ..................... 100 VAC to 240 VAC, 50/60 Hz, external,
universal; to 12 VDC, 2 A, regulated
Power input requirements ............... 12 VDC, 0.5 A
Temperature/humidity .................... Storage: -40 to +158 °F (-40 to +70 °C) /
10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) /
10% to 90%, noncondensing
Cooling ........................................... Convection, unvented
Rack mount ..................................... Yes, with optional 1U rack shelf, part
#60-190-01 or 60-604-01; or VersaTools
®
rack shelf, part #60-190-20 or 60-604-20
Also furniture mountable with optional Mini
Under-Desk Mounting Kit, part #70-212-01;
or projector mountable with optional
projector mounting kit, part #70-217-01
Enclosure type ................................ Metal
Enclosure dimensions ..................... 1.7" H x 4.3" W x 3.0" D (1U high, quarter
rack wide)
4.3 cm H x 10.9 cm W x 7.6 cm D
(Depth excludes connectors.)
Product weight ............................... 0.6 lbs (0.3 kg)
Shipping weight ............................. 2 lbs (1 kg)
Vibration ........................................ ISTA 1A in carton (International Safe Transit
Association)
Listings ............................................ UL, CUL
Compliances ................................... CE, FCC Class A, VCCI, AS/NZS, ICES
MTBF .............................................. 30,000 hours
Warranty ........................................ 3 years parts and labor
NOTE:
All nominal levels are at ±10%.
Model
Version Description
Part Number
MTP U R RSA SEQ A/V & RS-232 Universal Receiver w/SEQ ......... 60-869-01
MTP U R RS SEQ Video & RS-232 Universal Receiver w/SEQ ...... 60-869-02
MTP U R A
Video & Audio Universal Receiver ................... 60-869-03
MTP U R RS
Video + RS-232 Universal Receiver .................. 60-869-04