Extron electronics MPS 601, Руководство пользователя

Страница: 48 / 59

Status change messages
The switcher-initiated status change messages are a result of front panel operations (actual
or software-simulated). The status change messages are the same as switcher responses
to certain commands. See the last column of the command and response command tables
(see the
Command and Response Table ).
MPS Switcher Error Responses
When the MPS switcher receives an SIS command and determines that it is valid, it
performs the command and sends a response to the host device. If the switcher is unable
to perform the command because the command is invalid or contains invalid parameters, it
returns an error response to the host. The error response codes are:
E01
] — Invalid input channel number (too large)
E06 ] — Invalid switch command (due to auto-input switch enabled)
E10 ] — Invalid command
E13
]
— Invalid parameter (out of range)
E14 ] — Not valid for this configuration
E17 ] — Invalid command for signal type
E22 ] — Busy
Command and Response Table
Using the Command and Response Table
The command and response table is shown on the following pages. Lower case characters
are acceptable in the command field only where indicated. Symbols are used throughout
the table to represent variables in the command and response fields. Symbol definitions are
shown below. Command and response examples are shown throughout the command and
response table.
Symbol definitions
] = CR/LF (carriage return/line feed) (hex 0 D 0 A).
}
or
|
= Soft carriage return (no line feed, hex 0 D).
•
= Space character in command or response (all other spaces shown are for clarity).
W or
E
= Escape key (hex 1 B)
X!
= Inputs 0 through 6 for single input addressing ( 0 = deselect)
X# = Status
0 = off (disable), (default)
1 = on (enable)
X% = Signal Status
0 =no signal
1 =signal present.
X^
= HDCP authorized status
0 =Block or disable HDCP encryption.
1 =Allow or enable HDCP encryption (default).
X& = EDID slot number from lookup table (see
User Assigned EDID Mode
on page 16):
1 - 66 = factory EDIDs
67 = Output (autodetect)
68 - 71 = user loaded EDID slots
40 MPS 601 • Remote Communication and Control