Extron electronics mediaport 200, Руководство пользователя

Страница: 158 / 164

MediaPort 200 • Remote Configuration and Control 151
1
HDMI Status — Shows the resolution and refresh rate (
1
below) of the HDMI (or
DVI) input and loop-out (
4
), the input HDCP encryption status (
3
) and the HDCP
compliance of the attached sink (
6
).
NOTES:
• The
Input
panel (
2
) displays either
HDMI
or
DVI
, depending on the detected
input signal type.
• The
Loop-Out
panel (
5
) displays either
HDMI
or
DVI
, depending on the loop
output format that has been set.
Figure 95. HDMI Status Panel with HDCP Encrypted
•
Input panel:
•
If the input signal is HDCP encrypted , the Input status field displays a closed
lock icon followed by HDCP (see figure 95
3
above).
•
If the input signal is NOT HDCP encrypted , the Input status field displays an
open lock icon, followed by HDCP.
•
If no device is connected to the HDMI input , the input status field displays a
dash (–).
•
Loop-Out panel:
•
If the attached sink is HDCP compliant , the loop-out status field (
6
) displays a
lock icon with a check mark.
•
If the sink is non-HDCP compliant , this field displays an open lock icon with an
X on it.
•
If no device is connected to the Loop Out connector , the Loop-Out status
field displays a dash.
2
USB Status — This read-only panel indicates whether a USB host is present,
whether video and audio is being streamed, and if audio is being returned through this
connection input. It also displays the USB output resolution group, resolution rate, and
the USB streaming format.
figure 95.
HDMI Status Panel