For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the
Extron Safety and Regulatory Compliance Guide
on the Extron website
.
© 2019 Extron Electronics — All rights reserved.
www.extron.com
All trademarks mentioned are the property of their respective owners.
Worldwide Headquarters:
Extron USA West, 1025 E. Ball Road, Anaheim, CA 92905, 800.633.9876
68-3345-50 Rev. B
02 19
4
3. Configure Interface Properties
After adding the KNX 100G to a project, you can change the
Individual Address
and
IP
setting in
Properties
(see figure 7
below). In ETS 4, additional individual addresses will appear in the Topology view.
Within the ‘Settings’ overview, each individual KNX address and the device’s name can be changed. ‘Properties’ will appear on
the right side of the ETS window after clicking on the KNX 100G device entry within the project’s topology view. Click on the list
entry and type in the desired address into the
Individual Address
textfield to change an individual address (see
1
in Figure
6). If the textfield frame switches to color red after entering the address, the address is already taken within your ETS project.
NOTE:
Make sure none of the individual KNX addresses are in use within the KNX installation.
If the physical KNX addresses of the tunneling connections have been assigned via ETS, a manual address setting on
the device is not allowed.
The IP network specific options of the KNX 100G can be changed. In the ‘Properties’ window, click on the ‘IP’ tab. Change
Obtain an IP address automatically
to
Use a static IP address
to set the
IP address
,
subnet mask
, and
default gateway freely
2
.
Figure 6.
ETS Properties Settings
Figure 7.
ETS Properties IP
4. Program the KNX System
Via the KNX Bus
The device only needs to be connected to the KNX bus. ETS requires an additional interface to have access to the bus.
Both the individual address and the entire application can be programmed via the KNX bus. Programming via the bus is
recommended if no IP connection can be established.
Via KNXnet/IP Tunneling
No additional interface is required. Programming via KNXnet/IP Tunneling is possible if the device already has a valid IP
configuration. The device is displayed in the interface configuration of ETS and must be selected. The download is executed
via ETS.
1
KNX 100G
0.0.0
2