Extron electronics FOX3 SR 20, Руководство пользователя

Страница: 29 / 56

FOX3 SR 201 Scaling Receiver • SIS Configuration and Control 21
SIS Configuration
and Control
This section describes the remote control operation of the FOX3 SR 201 scaling receiver,
including:
•
Host Control Ports
• Simple Instruction Set Control
• Command and Response Table for SIS Commands
The FOX3 receiver can be configured using SIS commands, PCS, or embedded web
pages. The FOX3 receiver can be controlled using SIS commands or PCS. Configure and
control the FOX3 receiver remotely via a host computer or other device (such as a control
system) by connecting to the rear panel RS‑232 port, LAN port, or the front panel USB port.
NOTE: SIS commands and Product Configuration Software functions are receiver
specific or may have different responses depending on the unit connected. Connect
to the appropriate device for the command to work properly or to get the expected
response.
Host Control Ports
Rear Panel RS-232 Port
The FOX3 devices have a rear panel serial port (see figure 2 on page 5) that can be
connected to a host device such as a computer running Extron DataViewer, available at
www.extron.com . The port makes serial control of the FOX3 device possible. Use the
protocol information listed below to make the connection.
The protocol for the serial ports is as follows:
• 9600 baud • no parity • 8 data bits
• 1 stop bit • no flow control
Front Panel Configuration USB Port
The front panel mini B USB Configuration port (see figure 8 ,
B
on page 12) can be
connected to a host computer for configuration using SIS commands via an SSH client and
IP address
203.0.113.22 on port 22023 .
Ethernet (LAN) Ports
The rear panel Ethernet connector (see figure 2 on page 5) can be connected to an
Ethernet LAN or WAN. Communications between the receiver and the controlling device is
via an SSH client,using port
22023
. This connection makes SIS control of the unit possible
using a computer connected to the same LAN or WAN (see TP Cable Termination and
Recommendations on page 11 to wire the LAN connector).