NOTE:
Snap the included ferrite bead onto
the power supply cable, at a distance of
3.25 inches (8.25 cm) from the end of the
DC connector (see image at right).
3.25 inches
(8.25 cm)
C
HDMI Out connector
— Connect an HDMI cable between this port and the HDMI input connector of the display device.
The eLink 100 On-screen Display (OSD)
When the receiver is powered and connected to the display device, the On-screen Display (OSD) appears. The OSD offers
instructions and feedback while registering the transmitter with the receiver (see the following section).
NOTE:
For instructions on other OSD menus and features, see the
eLink 100 User Guide
.
Registering the Transmitter with the Receiver
To establish communication between the eLink 100 transmitter and receiver, the transmitter must be registered with the receiver.
After registration is performed at the initial setup, the transmitter and receiver connect automatically when booted.
The units can be registered using the eLink 100 remote control (see the
eLink 100 User Guide
for instructions) or using the register
buttons on the eLink 100 units (see the instructions below).
1.
Connect and apply power to the transmitter, video source device, receiver, and display device.
NOTE:
The registration process can be done without a video source device connected. In this case, a message appears
on the OSD, notifying you of a missing video source.
2.
Press and hold the Register button
on the receiver top panel until the
following message appears on the OSD:
Please
Activate Registration
on
Transmitter
Unit
.
3.
Press and hold the Register button on the
transmitter top panel until the following
message appears on the OSD:
Adding
transmitter
name
.
Press
OK
to
continue
or
Exit
to
cancel
4.
Press the Register button on the receiver
to confirm. The message
Adding
transmitter
name
...
and a progress
bar appear on the OSD while registration is
completing.
NOTE:
It may take up to 60 seconds for registration to complete. If the process is delayed more than 60 seconds, cycle
power on both units, then restart the registration process.
When registration is complete, the message and progress bar disappear from the display. The Link LED and the Video LED
light steadily, and the video is output on the display.
NOTE:
For instructions on controlling the OSD menus and features using the eLink 100 remote, see the
eLink 100 User
Guide
.
Registering an Additional Receiver
Up to four receivers can be linked to a single transmitter. To register an additional receiver to the transmitter:
1.
Power down all receivers except the one you are registering.
2.
Perform steps 2 through 4 above (Registering the Transmitter with the Receiver).
3.
When registration is complete, power on the other receivers to display the video on all monitors.
68-2662-50 Rev. B
10 14
©
2014 Extron Electronics All rights reserved. All trademarks mentioned are the property of their respective owners.
www.extron.com
Extron
eLINK 100 R
VIDEO
POWER
REGISTER
LINK
2
2
POWER
VIDEO
eLINK 100 T
LINK
REGISTER
RESET
Extron
3
3
Receiver
Transmitter