Maintenance and Modifications, cont’d
Digital XPoint Matrix Switchers • Maintenance and Modifications
6-6
TEXT
Separate two
piece button here.
Use notch to
remove button.
Creating and Installing Button Labels
Figure 6-5 on page 6-7 provides blank button labels. If desired, photocopy them or
cut them out of the manual, write button information in each button area as
desired, and put them in the switcher’s input or output button windows.
Use the following procedure to install new labels in the DXP’s front panel buttons.
1.
Make new labels using either the blanks on page 6-7 or the Button-Label
Generator software (see chapter 5, Matrix Software).
Cut them out.
2.
Remove the button from the DXP by grasping the
button firmly and pulling it away from the front
panel.
There are different button models available. Your
buttons may appear different.
3.
Use an Extron Tweeker to gently lever the clear
button cap off of the white backing plate.
4.
Insert a button label into the cap and gently but
firmly press the cap onto the white backing plate.
5.
Press the button into place in the DXP matrix
switcher.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
