Extron electronics DVS 605, Руководство пользователя, Страница: 63 / 133

DVS 605 • SIS Communication and Control 55
Command ASCII Command
(host to scaler
)
Response
(scaler to host
)
Additional Description
Video signal presence
View signal presence
0LS
X4$
*
X4$
*
X4$
*
X4$
*
X4$]
Signal status for input 1*2*3*4*5.
X4$
:
0
= no input,
1
= input detected.
KEY: X4$ = Video signal status: 0 = video or TMDS signal not detected, 1 = video or TMDS signal detected
Hardwired IR port
Enable IR port (allows
IR)
65*0# IRDisable0
]
Enable the hard wired port and allows IR control
input.
Disable IR port (blocks
IR)
65*1# IRDisable1
]
Disable the hard wired port (default).
View IR setting
65#
X(] View the current IR Disable setting.
KEY:
X(
= Enable or disable:
0
= off or disable,
1
= on or enable
On-Screen Menu time-out
NOTE: Setting the time-out to
501
disables the OSD time-out (never times out). Setting the time-out to
0
disables the OSD.
Set menu time-out
EX2%
MDUR
}
Mdur
X2%] Set the OSD to X2% seconds.
View time-out
E
MDUR
} X2%]
View time-out settings.
KEY:
X2%
= On-screen menu time-out: (default = 3 seconds) output sync time-out (default =
501
- never)
0 = OSD never displayed or output sync is instantly disabled with no active input,
1 to 500 in 1 second increments, 501 = OSD never times out or output sync never times out
Reset commands
Erase user Web pages
and files
24 28
E
<filename> EF
}
Del
•
<filename>
]
Erase named file.
Erase current directory
and files
24 28
E
/EF
}
Ddl
]
Erase current directory and its files.
Erase current directory
and subdirectories
24 28
E
//EF
}
Ddl
]
Erase current directory and its subdirectories.
Erase flash memory
24 E
ZFFF
}
Zpf
]
Erase the flash memory.
Reset all device
settings to factory
default settings
24
E
ZXXX
}
Zpx
]
Retain Ethernet settings
NOTE: The factory configured passwords for all accounts on this device have been set to the device serial number. In the event
of a complete system reset, the passwords convert to the default, which is no password (see Password Page on page 121 to
change the password).
Absolute system reset
24 E
ZQQQ
}
Zpq
]
Reset networking to DHCP = Off,
IP =
192.168.254.254
(default address)
Absolute system reset
(retains IP)
24
E
ZY
}
Zpy
]
NOTE: This reset
E
ZY i
s similar to
ZQQQ
but excludes IP address, subnet mask, gateway addresses, unit name, DHCP setting,
and port mapping (Telnet or web or direct access) in order to maintain communications with device. Recommended after a
firmware update.