DVS 510 Series • Operation
24
Selecting an input
To select an input, press the numbered input button. The button
lights amber. The selected input number is displayed in the LCD
window on the first screen of the default cycle. Inputs can also
be selected via an SIS command, the SPPCP software, the web
pages, and the IR 904 remote control.
Configuring an input
Follow these steps to configure any of the 10 video inputs:
1.
Press the numbered button for the input to configure.
2.
Press the
MENU
button until
Input
Configuration
is displayed in the LCD window
(see
on the previous page.
3.
Press the
NEXT
button repeatedly until the desired input parameter submenu is
displayed.
4.
Rotate either
ADJUST
knob until the desired submenu option is displayed.
NOTE:
For EDID settings, rotate the horizontal knob (
[
) to adjust the resolution
and the vertical
ADJUST
knob (
{
) to select a refresh rate (inputs 5, 6, 8, and 10
only).
5.
To save the input configuration, press
MENU
once or
NEXT
repeatedly to return to the
top level menu.
Alternatively, wait for the LCD display to time out and return to the default cycle
(approximately 30 seconds). The DVS saves the new settings.
NOTE:
Depending on the signal type of the selected input, different adjustments are
available for the different inputs (see the table below).
Available input adjustments
The following table shows which adjustments are available for each input type.
Composite
(Inputs 1
and 2)
S-video
(Inputs
3 and 4)
RGB
(Inputs 5, 6,
7, and 9)
YUVp/HDTV
(Inputs 5, 6,
7, and 9)
RGBcvS
(Inputs 5,
6, 7, and 9)
YUVi
(Inputs 5,
6, 7, and 9)
DVI
(Inputs 8
and 10)
Film Detect
X
X
X
X
X
X
X
Vert. Start
X
X
Horiz. Start
X
X
Pixel Phase
X
X
Total Pixels
X
X
Active Pixels
X
X
X
X
X
X
X
Active Lines
X
X
X
X
X
X
X
EDID
X
(Inputs 5 and
6 only)
X
In #5 RGB
47.8kHz 60.0Hz
