Extron electronics DTP2 T 202 FB, Руководство пользователя

Страница: 17 / 40

DTP2 T 202 FB • Installation and Operation 9
D
TP connector
(see
figure 7
on page 7) — Plug one end of an STP cable
LINK SIG
OUT
to this RJ-45 female jack. Plug the opposite end of this cable into the DTP2
Input RJ-45 connector on a compatible receiver (see
TP cable
termination and recommendations
on page 16 to properly wire the
RJ-45 connector and for detailed
NOTES
).
Signal LED indicator — Lights green when the transmitter outputs a video signal.
Link LED indicator — Lights yellow when XTP devices are connected and
communication is established.
ATTENTION:
•
Do
NOT
use the transmitter to remotely power a legacy DTP receiver. Circuit
damage to the transmitter
WILL
result.
• NE PAS utiliser le l’émetteur pour alimenter à distance un récepteur de la
gamme existante DTP. Cette opération FINIRA par endommager le circuit
menant à le récepteur .
• Do not connect this connector to a computer data or telecommunications
network.
• Ne connectez pas ces port à des données informatiques ou à un réseau de
télécommunications.
E
Send Power toggle switch — In a system with a DTP2 receiver, set
SEND POWER OFF
the toggle switch to the Send
Power
position (left) on the powered unit to
enable sending power to the unpowered unit. Set the toggle switch to the
Off
position
(right) on the DTP2 unit that is to receive power.
F
TP function switch —
HDBT DTP
ATTENTION :
•
Position this switch
BEFORE
connecting the appropriate device to the TP
connector. Failure to comply can damage the endpoint.
• Positionnez le sélecteur AVANT de connecter l’appareil approprié au
connecteur TP. Ne pas respecter cette procédure pourrait endommager le
point de connexion.
If the connected receiving device is in the Extron DTP2 series, set this switch to the
DTP position (right). For an HDBaseT-enabled receiver type, set this switch to the HDBT
position (left). This switch tailors the output signal as follows:
•
HDBT position — The TP output consists of HDMI with embedded audio plus
RS-232 and IR.
•
DTP2 position — The TP output consists of HDMI with embedded audio, analog
audio, RS-232 and IR, and remote power.
NOTES:
• When the switch is in the HDBT position
, the transmitter and receiver each
requires a local 12 VDC power supply.
• When the switch is in the DTP2 position , one 12 VDC power supply,
connected to either the transmitter or the receiver, can power both units so
long as both are DTP2 and the Send Power switch on one of the units is in the
Send
Power
position and Send Power on the other unit is in the
Off
position.