Extron electronics DTP2 R 212 Series, Руководство пользователя

Страница: 14 / 68

DTP2 R 212 Series • Installation 6
Installation
This section describes the installation and setup of the DTP2 R 212 switcher. Topics include:
•
Installation Overview
• Rear Panel Features
• Wiring Connections
• LockIt Lacing Brackets
Installation Overview
To install and set up the DTP2 R 212 switching receiver:
1. Turn off all equipment and disconnect it from the power source.
2. Mount the switcher (optional) on a rack shelf or furniture (see Mounting the
DTP2 R 212 on page 58).
3. Connect an HDMI input source to the DTP2 R 212 input. The default (Extron) EDID is
present and Hot Plug Detect (HPD) is actively controlled on the input.
NOTE: LockIt cable lacing brackets are provided to secure the HDMI cables to the
rear panel ports to reduce stress on the HDMI connectors and prevent signal loss
due to loose cable connections (see the
LockIt Lacing Brackets on page 17).
4. Connect an HDMI output device to the HDMI output. By default, the EDID of this
device is stored at the HDMI inputs.
5. Connect an RJ-45 DTP2 transmitting device to the
DTP2 In
connector (see
figure 3 ,
D
on page 7), set the SEND POWER switch (
E
).
ATTENTION:
• Position this switch (see figure 3 ,
E
) BEFORE connecting the appropriate
device to the TP connector. Failure to comply can damage the endpoint.
• Positionnez le sélecteur (voir figure 3 ,
E
) AVANT de connecter l’appareil
approprié au connecteur TP. Ne pas respecter cette procédure pourrait
endommager le point de connexion.
• If the transmitting device is in the Extron DTP2 series and you are setting up the
DTP2 R 212 receiver to
supply
power to the transmitter:
• Set the receiver SEND POWER switch (see figure 3 ,
E
) to the “UP” (SEND
POWER) position (see figure 4 on page 9).
• Set the transmitter SEND POWER switch (see figure 3 ,
E
) to the “DOWN”
(OFF) position.
•
If the transmitting device is in the Extron DTP2 series and you setting up the
DTP2 R 212 (non‑amplifier model) to
receive power from the transmitter:
• Set the receiver SEND POWER switch of the receiver (see figure 3 ,
E
) to the
“DOWN” (OFF) position (see figure 4 on page 9).
• Set the transmitter SEND POWER switch (see figure 3 ,
E
) to the “UP”
(SEND POWER) position.